ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Process triggers even though start condition is not met when marking investments for deletion
Article ID: 111580
Updated On:
Products
Clarity PPM SaaS
Clarity PPM On Premise
Issue/Introduction
Process triggers even though start condition is not met when marking investments for deletion.
Cause
1. Create a new process which starts on update of Manager change (( Project Manager != Project Manager [Previous Value] ))
2. Navigate to an Active Project
3. Change the "Financial Status" of the Project to "Closed"
4. "Uncheck" the "Active" check-box
5. From the Project List View, Mark the Project for Deletion by "Checking" the Project and "Click" the "Mark for Deletion" button
6. Navigate to the Process tab of the Project. Note that the new process that we have created would have triggered. It should not have triggered as we did not update the "Manager" field
2. Navigate to an Active Project
3. Change the "Financial Status" of the Project to "Closed"
4. "Uncheck" the "Active" check-box
5. From the Project List View, Mark the Project for Deletion by "Checking" the Project and "Click" the "Mark for Deletion" button
6. Navigate to the Process tab of the Project. Note that the new process that we have created would have triggered. It should not have triggered as we did not update the "Manager" field
Environment
Release: CODFSS99000-15.4.1-PPM SAAS FedRAMP-Sandbox-Small Environment
Component:
Component:
Resolution
Defect DE43422, Fixed in 15.5.1.
Feedback
Yes
No
Powered by
