change severity of netapp_ontap Self-Monitoring Failure alarms
book
Article ID: 110075
calendar_today
Updated On:
Products
DX Infrastructure ManagementNIMSOFT PROBES
Issue/Introduction
Is there a way to configure the Self-Monitoring Failure alarm, SubSystem 5.5, for the netapp_ontap probe so it can either be suppressed or alarm severity changed at the probe level?
Environment
Release: Component: UIMNOT
Resolution
Self-monitoring alarms severity can be set using setup key; self_monitoring_alarm_severity and set it to desired number (5-Critical, 4-Major, 3-Minor, 2-Warning, 1-Informational), Default is 4. This is set in the section of the Raw Configure for the probe.
To disable the Self Monitoring Alarms entirely: Setup key: enable_self_monitoring_alarm_aggregation = false