change severity of netapp_ontap Self-Monitoring Failure alarms

book

Article ID: 110075

calendar_today

Updated On:

Products

DX Infrastructure Management NIMSOFT PROBES

Issue/Introduction

Is there a way to configure the Self-Monitoring Failure alarm, SubSystem 5.5, for the netapp_ontap probe so it can either be suppressed or alarm severity changed at the probe level?

Environment

Release:
Component: UIMNOT

Resolution

Self-monitoring alarms severity can be set using setup key;
self_monitoring_alarm_severity and set it to desired number
(5-Critical, 4-Major, 3-Minor, 2-Warning, 1-Informational), Default is 4.
This is set in the section of the Raw Configure for the probe.

To disable the Self Monitoring Alarms entirely:
Setup key:
enable_self_monitoring_alarm_aggregation = false