JCLCHECK issue improper CAY6046E DYNAMNBR error when DYNAMNBR=3000

Products

• CA JCLCheck Workload Automation

Issue/Introduction

JCLCheck validation is displaying an improper CAY6046E error when DYNAMNBR=3000 is used on an EXEC statement.
CAY6046E "3000" IS TOO LARGE A VALUE FOR "DYNAMNBR"  PARAMETER OF "EXEC"           
It looks like the JCLCheck maximum DYNAMNBR is based on TIOT of 32k. Errors are displayed on values over 1635. 

Cause

Problem most likely to occur when the parameter value for DYNAMNBR is greater     
than a value of 1635.                       

Environment

Release:
Component: JCLCHK

Resolution

APAR ST04480 corrects the issue with JCLCHECK improperly issuing message CAY6046E "nnnn" IS TOO LARGE A VALUE FOR "DYNAMNBR" PARAMETER  OF "EXEC"