DDPURT0200 error message
Article ID: 109010
Updated On:
Products
Datacom
DATACOM - AD
Issue/Introduction
I am upgrading to release 12 on our production machine but before I can do that I have to get release 11 up to SP05, it is at SP03 right now.
hen I refresh my library with SP05 and bring up MUFF everything seems ok but as it indicates in Special Action Required for SP4. Bullit 7) says to run DD11SP41.
When I run that job i get the DDPURT0200 error. Attached is the output from the job.
Message received:
**** ERROR **** RETURN CODE = DDPURT0200 CANNOT FIND URT
URT = DDURTBL
hen I refresh my library with SP05 and bring up MUFF everything seems ok but as it indicates in Special Action Required for SP4. Bullit 7) says to run DD11SP41.
When I run that job i get the DDPURT0200 error. Attached is the output from the job.
Message received:
**** ERROR **** RETURN CODE = DDPURT0200 CANNOT FIND URT
URT = DDURTBL
Environment
z/VSE CA Datacom 12.0
Cause
The reason for the error is due to a bad DDSYSTBL macro parameter value.
Most likely parameter URTBL=
Resolution
Please verify which value you have for the URTBL parameter.
It should be URTBL=DDURT002.
Also, you may check value for the MULTURT parameter.
It should be MULTURT=YES.
From your message it sounds that DDSYSTBL is coded: URTBL=DDURTBL
Modifying the value to DDURT002 resolved the problem.
It should be URTBL=DDURT002.
Also, you may check value for the MULTURT parameter.
It should be MULTURT=YES.
From your message it sounds that DDSYSTBL is coded: URTBL=DDURTBL
Modifying the value to DDURT002 resolved the problem.
Additional Information
DDPURT0200 - CANNOT FIND URT
Reason: The User Requirements Table specified in the System Resource Table is not available.
Action: Assure a valid User Requirements Table is available.
Feedback
Yes
No
Powered by
