[ASO] Error 404 while generating oauthserver.out for SNOW connector
book
Article ID: 107924
calendar_today
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Automic Service Orchestration Scenario: re-install 12.2 (from 12.1) and configure ASO for SNOW using the 12.2 installation media and the original config’s for reference, Issue:
Token was successfully generated, but when while the token is used against the SAPI, there's a 404 page not found error and no oauthserver.out file is generated.
Even if ASO components are removed and then reinstalled, at the same point the same result would still happen.
Please find below screenshot for the command used:
<Please see attached file for image>
Environment
Release: Component: AAUTEN
Resolution
According to the screenshot, it appears that there is a case-sensitive issue: where http://localhost:8080/sapi/services should be used instead of http://localhost:8080/sapi/SERVICES Please check the syntax