ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Why are we seeing devices being discovered in Spectrum and immediately placed into Maintenance Mode
Article ID: 107683
Updated On:
Products
CA Spectrum
Issue/Introduction
Why are we seeing devices being discovered in Spectrum and immediately placed into Maintenance Mode
Cause
The most likely reason is the "Unmanaged Trap Discovery" parameter in the "AutoDiscovery Control" -> "Trap Based Continuous Discovery" subview in the Information tab of the VNM model is set to Enabled and the "New Devices In Maintenance" parameter in the same subview is set to Yes.
Environment
Release: Any
Component:
Component:
Resolution
This is functioning as designed.
Additional Information
Please reference the "AutoDiscovery Control Subview" section of the documentation for more information.
Feedback
Yes
No
Powered by
