ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Update single Data Aggregator to a Fault Tolerant Data Aggregator pair
Article ID: 106985
Updated On:
Products
CA Infrastructure Management
CA Infrastructure Management
CA Performance Management - Usage and Administration
DX NetOps
Issue/Introduction
Can the Data Aggregator (DA) in an existing DX NetOps Performance Management environment be converted to a Fault Tolerant Data Aggregator pair?
Can this be done without an upgrade?
Environment
All supported DX NetOps Performance Management releases
Resolution
CA Performance Management installations cannot be converted to Fault Tolerant Data Aggregators outside of an upgrade or fresh install.
During the install or upgrade process, there are prompts to configure Fault Tolerance.
Additional Information
For instructions on how to configure Fault Tolerant Data Aggregators during Fresh Install or upgrade see:
Feedback
Yes
No
Powered by
