ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
How to set up CA PPM Jaspersoft with HTTPS?
Article ID: 106122
Updated On:
Products
Clarity PPM On Premise
Issue/Introduction
How to set up CA PPM Jaspersoft with HTTPS?
Can't find documentation within CA PPM on how to configure HTTPS.
Environment
CA PPM 15.3 (or any), with Jaspesoft and SSL or HTTPS required.
Resolution
HTTPS is a subset of SSL.
This is controlled by Jaspersoft, and not CA PPM.
See these documents for advice on configuring this.
For example, page 27 from here:
https://community.jaspersoft.com/documentation/jasperreports-server-ultimate-guide/v55/using-ssl-web-server
https://comm.support.ca.com/kb/i-configured-jaspersoft-reports-to-use-https-mode-but-the-reports-time-out-or-give-a-mixed-mode-content-error-message/kb000046656#/
http://community.jaspersoft.com/questions/542493/how-setup-ssl-configuaration-jasperserver
This is controlled by Jaspersoft, and not CA PPM.
See these documents for advice on configuring this.
For example, page 27 from here:
https://docs.tibco.com/pub/js-rptsrvr-amxbpm/6.2.0/doc/TIB_js-rptsrvr-amxbpm_6.2.0_Security.pdf
https://community.jaspersoft.com/documentation/jasperreports-server-ultimate-guide/v55/using-ssl-web-server
https://comm.support.ca.com/kb/i-configured-jaspersoft-reports-to-use-https-mode-but-the-reports-time-out-or-give-a-mixed-mode-content-error-message/kb000046656#/
http://community.jaspersoft.com/questions/542493/how-setup-ssl-configuaration-jasperserver
Feedback
Yes
No
Powered by
