ATTEMPT TO LOAD PROGRAM FAILED

Products

• IDMS
• IDMS - Database

Issue/Introduction

While attempting any IDMS utility, a message similar to this is displayed on the screen:

ATTEMPT TO LOAD PROGRAM FAILED:
PMRTSCHK

The load module is present as is proven by the command LOOK PROGRAM=PMRTSCHK.

The module identified (in this case PMRTSCHK) could be anything.

Environment

Component: Performance Monitor.
Release: Any supported release.

Cause

The most likely cause of this message is that the module identified is not defined to the IDMS System Generation.

Resolution

There are two likely reasons why the definition is missing.

1. The module was added by a recent APAR and HOLDDATA for that APAR (which would add the SYSGEN definition) has not been followed.
   
   - OR -
   
   
2. One or more of the configuration steps was omitted. In particular, ensure that Job 9: SYSTEM and SYSDIRL Dictionaries and Job 17: Generate SYSTEM 90 were completed successfully. Also be sure that the PROGRAMS and TASKS are copied from SYSTEM 99 not only to SYSTEM 90 but also to the SYSTEM number that the CV actually uses (SYSTEM 90 is a demonstration system only and the CV most likely uses its own number).

Example:

SIGNON DICTIONARY SYSTEM.
COPY PROGRAMS FROM SYSTEM 99 TO nnn.
COPY TASKS    FROM SYSTEM 99 TO nnn.
GENERATE.

Additional Information

Generated Configuration Tasks