CA PMO 4.4 How to test if PMO/XCF works as it is expected
Article ID: 105963
Updated On:
Products
PMO Runtime Performance Optimizer
Issue/Introduction
Are there steps to test PMO/XCF function in CA PMO 4.4 ?
Environment
CA PMO 4.4
Resolution
1) Add a library to PMO on SYSTEMA and SYSTEMB, make it a relatively small non-load library and access several members from both systems ? you could use ISPF Browse.
2) Run an offline report on SYSTEMA: F PMO,PRVTRPT=data.set.name
3) That output goes to the PMO STC and it includes the starting TTR for members accessed since the library was added to PMO.
4) Now update a member in that library on SYSTEMB.
5) Run the offline report again on SYSTEMA ? the updated member should have the correct TTR.
2) Run an offline report on SYSTEMA: F PMO,PRVTRPT=data.set.name
3) That output goes to the PMO STC and it includes the starting TTR for members accessed since the library was added to PMO.
4) Now update a member in that library on SYSTEMB.
5) Run the offline report again on SYSTEMA ? the updated member should have the correct TTR.
Feedback
Yes
No
Powered by
