ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
How do you set the Performance Management installers into debug
book
Article ID: 105798
calendar_today
Updated On:
Products
CA Infrastructure ManagementCA Performance Management - Usage and Administration
Issue/Introduction
How to set the Performance Management installers into debug?
Environment
Release: Component: IMADMN
Resolution
1.
Enter one of the following (based on which shell is being used) at the command line:
export LAX_DEBUG=true
setenv LAX_DEBUG true
LAX_DEBUG=true
set LAX_DEBUG
Note: Use whatever syntax is appropriate for the UNIX shell being used.
2.
Run the installer.
The output that is produced is sent to the console.