NETSTAT command and some displays fail in Netmaster if stackname starts with 'I'
book
Article ID: 105673
calendar_today
Updated On:
Products
CMDB for z/OSNetSpy Network PerformanceNetMaster Network AutomationSOLVENetMaster Network Management for SNANetMaster Network Management for TCP/IPNetMaster File Transfer Management
Issue/Introduction
Any NETSTAT command, or any display using a NETSTAT command that requires the name of the TCPIP stack fails if the stackname starts with the letter "I". Result: IPCALL34 NETSTAT parameter (INTERVAL) not supported
Example: NETSTAT TTLS TCP IPTCP1 CONN 000000FE DETAIL fails to return any output. IPTCP1 is the valid stack name
Changing the command to NETSTAT TTLS TCP=IPTCP1 CONN 000000FE DETAIL works
Removing TCP IP1NET works, but this appears to be hardcoded for some displays.
an XDB debug suggests it is matching on the I of IP1NET and thinking it is the INTERVAL parmeter then flagging up and error that INTERVAL is invalid
Environment
Release: SLOPFC00200-12.2-NetMaster-File Transfer Management Component:
Cause
Debug suggests it is matching on the I of IP1NET and thinking it is the INTERVAL parameter then flagging up an error that the INTERVAL is invalid