UIM Probe administration - IP write mask defaults

book

Article ID: 105636

calendar_today

Updated On:

Products

DX Infrastructure Management NIMSOFT PROBES

Issue/Introduction



I have noticed in probe administration that there an individual IP address for some probes and IP mask for others.
Are these put in place by default when the application is installed?
If they are not what is the default for the IP mask when the application is installed?

 

Environment

UIM 9.0 and earlier
HUB 7.95 and earlier

Resolution

When the UIM application is installed we do not know about the IP schema it will be installed to.
By default all IP mask for probe administration start out as wild card of an *.
If any individual IP or IP mask is set then this has been changed by and local administrator.