Telon Imports a DB2 Table into the TDF

Products

• Telon Application Generator

Issue/Introduction

What steps are needed for Telon to handle the Importing of a DB2 Table into the TDF? 
 

Environment

Telon Application Generator, release 5.1

Resolution

The source for the CA Telon program of TNMCDB2I is located in highlevelqual.CAWLSRC(#DB2ICOB). 
2. Each site makes modifications to the source to fit their shop standards. 
3. Then the following JCL is run:

//* DB2 PRE COMPILE OF TNMCDB2I 
//************************************************ 
//DB2PC EXEC PGM=DSNHPC,REGION=4096K, 
// PARM=('SOURCE','HOST(IBMCOB)','APOST') 

//* COMPILE THE GENERATED PROGRAM 
//***************************************************************** 
//COB EXEC PGM=IGYCRCTL,REGION=512K,COND=(5,LT,DB2PC), 
// PARM='SOURCE,MAP,LIST,SSRANGE,LIB,APOST,NOSEQ,RENT,XREF' 

//* LINK THE GENERATED PROGRAM 
//************************************************************ 
//LKED EXEC PGM=IEWL,REGION=1024K, 
// PARM='MAP,XREF,LIST,NORENT,REUS,AMODE=31,RMODE=24' 
//SYSIN DD * 
INCLUDE SYSLIB(DSNELI) 
ENTRY TNMCDB2I 
NAME TNMCDB2I(R) 

//********************************************************* 
//* DB2BIND - BIND THE PLAN FOR THE SQL INTERFACE 
//SYSTSIN DD * 

DSN SYSTEM(xxxx)     <==== where 'xxxx' is the Db2 subsystem
BIND PLAN(TNMCDB2I) MEMBER(TNMCDBRM) ACT(REPLACE) ISOLATION(CS) 
END 
/* 
//SYSIN DD * 
GRANT EXECUTE ON PLAN TNMCDB2I TO PUBLIC; 

Additional Information

Since TNMCDB2I is dynamically called, it must be available to the Telon Design Facility at runtime.