ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
How to run a Spectrum PView Health Report from the command line on Linux to run in the background
Article ID: 104346
Updated On:
Products
CA Spectrum
Issue/Introduction
How to run a Spectrum PView Health Report from the command line on Linux to run in the background
Environment
Release: Any version of Spectrum running on Linux
Component:
Component:
Resolution
1. Log into the Linux SpectroSERVER system as the user that owns the Spectrum installation
2. cd to the $SPECROOT/PView directory and enter the following command where <VNM> is the hostname of the SpectroSERVER system, <TIME> is the collection time in hours to collect data (6 hours minimum) and <ADDR_LIST> is the comma delimited e-mail address list to e-mail the report to when done.
./pviewrep <VNM> -c <TIME> -e <ADDR_LIST> > /dev/null 2>&1 &
pviewrep will run in the background for the time specified. Running in the background will allow the user to log out of the system.
2. cd to the $SPECROOT/PView directory and enter the following command where <VNM> is the hostname of the SpectroSERVER system, <TIME> is the collection time in hours to collect data (6 hours minimum) and <ADDR_LIST> is the comma delimited e-mail address list to e-mail the report to when done.
./pviewrep <VNM> -c <TIME> -e <ADDR_LIST> > /dev/null 2>&1 &
pviewrep will run in the background for the time specified. Running in the background will allow the user to log out of the system.
Additional Information
Please reference the "Run Health Reports from the Command Line" section of the documentation for more information
NOTE: In order for the e-mail to work, the mail server must be configured on the system.
NOTE: In order for the e-mail to work, the mail server must be configured on the system.
Feedback
Yes
No
Powered by
