ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Installing and Using VS Catalog for DevTest 10.3.0
Article ID: 103721
Updated On:
Products
CA Application Test
Service Virtualization
CA Continuous Application Insight (PathFinder)
Issue/Introduction
Virtual Service Catalog provides a central repository for viewing and sharing virtual services. From a single dashboard, you can quickly the available services that are deployed to a VSE and accessible in any Enterprise Dashboard that is connected to Virtual Service Catalog.
The VS Catalog is a new component introduce with DevTest 10.3.0
The VS Catalog is a new component introduce with DevTest 10.3.0
Environment
Note: Virtual Service Catalog cannot be run as a service at this time. However, most operating systems allow you to run an executable at start up.
Resolution
Here is the documentation on VS Catalog for DevTest 10.3.0:
https://docops.ca.com/devtest-solutions/10-3/en/installing/installing-virtual-service-catalog
https://docops.ca.com/devtest-solutions/10-3/en/using/using-virtual-service-catalog
https://docops.ca.com/devtest-solutions/10-3/en/using/using-virtual-service-catalog/configure-virtual-service-catalog
https://docops.ca.com/devtest-solutions/10-3/en/installing/installing-virtual-service-catalog
https://docops.ca.com/devtest-solutions/10-3/en/using/using-virtual-service-catalog
https://docops.ca.com/devtest-solutions/10-3/en/using/using-virtual-service-catalog/configure-virtual-service-catalog
Additional Information
There are videos within the documentation that shows installing and using VS Catalog.
Feedback
Yes
No
Powered by
