ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Cannot Specify Concurrent Capacity in MarInfo for DevTest 10.1.0
Article ID: 103547
Updated On:
Products
CA Application Test
Service Virtualization
CA Continuous Application Insight (PathFinder)
Issue/Introduction
When creating or editing a MarInfo file, I'm unable to set the concurrent capacity even though performance VSE is enabled.
Environment
DevTest 10.1.0
Resolution
patch_DE345898_10.1.0_GA.jar resolves this issue.
Please open a support case and refer to defect DE345898.
Please open a support case and refer to defect DE345898.
Feedback
Yes
No
Powered by
