Job is running before its predecessors complete
Article ID: 103102
Updated On:
Products
Jobtrac
Issue/Introduction
How to determine if an event is correctly set up so that it does not run before its predecessor completes?
Environment
Release:
Component: JOBTRC
Component: JOBTRC
Resolution
Any job that is set up with predecessors should wait until the predecessor events successfully complete their execution
before that event can be submitted. If an event runs before its predecessors, it may be that the SCL is set up incorrectly
and no actual predecessor events were defined. Select the event in question from the checkpoint by placing an 'S' by
it and verify whether the Schedule Event Detail shows any predecessor events are define. To add the appropriate
predecessors, update the SCL to include the desired predecessors in the Successor/Predecessor field.
As always, please contact CA Technologies Support for CA Jobtrac Job Management if you have further questions.
before that event can be submitted. If an event runs before its predecessors, it may be that the SCL is set up incorrectly
and no actual predecessor events were defined. Select the event in question from the checkpoint by placing an 'S' by
it and verify whether the Schedule Event Detail shows any predecessor events are define. To add the appropriate
predecessors, update the SCL to include the desired predecessors in the Successor/Predecessor field.
As always, please contact CA Technologies Support for CA Jobtrac Job Management if you have further questions.
Feedback
Yes
No
Powered by
