Unable to Edit Assignment Finish Dates

Article Id: 103041

Status: Published

Updated On: 05-07-2018 08:51

Products:

CLARITY PPM FOR ITG CA Project & Portfolio Management CLARITY PPM FEDERAL CA Project & Portfolio Management SAAS STARTER PACK-CLARITY PPM

Issue/Introduction:

I am unable to make changes to assignment finish dates. When I manually adjust the finish dates on the assignment, the date reverts back after saving. I am only able to change the finish date and have the new date stick when adding ETC hours to that assignment.

Environment:

Release: CODFSS99000-15.4.1-PPM SAAS FedRAMP-Sandbox-Small Environment
Component:

Resolution:

This is working as designed. When an assignment has no work (ETC hours) remaining, PPM assumes that the assignment was finished on the date that the last actuals were posted. This date will be the assignment's finish date, unless they are provided more work (ETC hours) to complete. This behavior will occur regardless if a task is fixed duration task.

Additional Information:

KB000051722: Unable to edit a Task Start and Finish Date when Actuals have been posted and there is no ETC