ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
CA PPM Project Status reports displaying incorrectly
Article ID: 102730
Updated On:
Products
Clarity PPM SaaS
Clarity PPM On Premise
Issue/Introduction
After adding a value to the INV_TYPE table, there appears to be some issues with how projects are displaying in reports. The "project status report list" report is showing the stage progress bar incorrectly. For "Phase-0" its showing the green box at the end of the progress bar rather than at the start which is where it should be for this phase.
Example:
Additionally the "project status summary" report is showing multiple groups for each phase rather than one group for each phase.
Example:
<Please see attached file for image>
Additionally the "project status summary" report is showing multiple groups for each phase rather than one group for each phase.
Cause
The data in Data Warehouse was not properly in sync as it should have been.
Environment
CA PPM 15.1 and above
Resolution
After running the FULL Data Warehouse Load, both reports are now displaying properly.
Attachments
Feedback
Yes
No
Powered by
