How to disable a confirmation Panel for command DSI (Desired State Inactive)?

Products

• SOLVE:Operations Automation
• SOLVE:Access Session Management
• SOLVE:FTS
• SOLVE

Issue/Introduction

When issuing a DSI command against a resource that is defined in an Service a Confirmation Panel is displayed. This Document shows how that Confirmation can be removed.

Environment

Release: SLFTS.00200-12-SOLVE:FTS
Component:

Resolution

When issuing a DSI command against a resource that is defined in an Service a Confirmation Panel like this is displayed:

 

REGION---------------- ServiceView : Override Warning ----------------
Command ===>                                           Scroll ===> CSR
 
+--------------------------------------------------------------------+
!    Resource STC(aaaaaaaa) has had a DSI command performed on it.   !
!      Below are listed all affected Resource(s) and Service(s).     !
!      Select CANCEL to terminate the DSI request at this point.     !
+--------------------------------------------------------------------+
 
+ Affected Services and Resources -----------------------------------+
!                                                                    !
!  System   Class  Name            Actual   Mode      Ovr Service(s) !
!  ssssssss  STC   aaaaaaaa        ACTIVE   AUTOMATED     RESOURCES  !
!                                                                    !
!     **END**                                                        !
!                                                                    !
!                                                                    !
!  F1=Help     F2=Split                         F5=Find    F6=Action !
!  F7=Backward F8=Forward  F9=Swap                        F12=Cancel !
+--------------------------------------------------------------------+

 

In case you want to disable this confirmation you can update the DSI command as follows:

 

1. Go to /ASADMIN.C (Automation Services : Command List) and select the DSI command with line command 'U'.
   
   
2. In the second panel titled "Prompting, Confirmation and Validation" change the value of "Does This Command Require Confirmation?" to NO:
   

   + Confirmation ------------------------------------------------------+
   !  Does This Command Require Confirmation? ... NO  (YES or NO)       !
   !  Confirmation Exit ...                                             !
   +--------------------------------------------------------------------+

3. Hit PF03 to save the changes. The Command List is displayed again and message RMPD0003 UPDATE COMPLETED SUCCESSFULLY shows the successful update.