how to check the new setting for LOG-BUFFER-MAXSIZE ( CICSLOGR parmlib)
Article ID: 101513
Updated On:
Products
SYSVIEW Performance Management
NXBRIDGE - SYSVIEW/ENDEVOR
Issue/Introduction
The customer just added in PARMLIB member CICSLOGR the parameter:
LOG-BUFFER-MAXSIZE 512M
Is there any way to check if this new setting is actually used?
LOG-BUFFER-MAXSIZE 512M
Is there any way to check if this new setting is actually used?
Environment
Release:
Component: SYSVW
Component: SYSVW
Resolution
SYSVIEW does not display the setting of LOG-BUFFER-MAXSIZE. The only place you can verify this is in the CICSLOGR PARMLIB member.
On CICSLOGR display you can see the total size of each CICSLOGR buffer in the BufTot column. This will show you the high water mark that the buffer has used. If the buffer grew to 512M, you would see it here.
On CICSLOGR display you can see the total size of each CICSLOGR buffer in the BufTot column. This will show you the high water mark that the buffer has used. If the buffer grew to 512M, you would see it here.
Feedback
Yes
No
Powered by
