FT Failover Secondary Archive Manager Switched and not starting
Article ID: 100735
Updated On:
Products
CA Spectrum
Issue/Introduction
Spectrum Archive Manager is switched to secondary and will not start.
When reviewing the $SPECROOT/SS/DDM/ARCHMGR.OUT file it contains just a couple of lines:
Apr 30 09:35:06 : ArchMgr started as user 'user'
Apr 30 09:35:06 : ArchMgr validating database.
When reviewing the $SPECROOT/SS/DDM/ARCHMGR.OUT file it contains just a couple of lines:
Apr 30 09:35:06 : ArchMgr started as user 'user'
Apr 30 09:35:06 : ArchMgr validating database.
Environment
Release: 10.3.x , 10.4.x
Component: SPCAEM
Component: SPCAEM
Resolution
This is functioning as designed.
When the Archive Manager is started it sends a CHECK TABLE event; query to mysql.
Pending database size this can potentially take hours.
If the secondary Archive Manager is running and connected - there is no problem to be concerned with.
If there is no secondary, you may opt to remove all the archive manager data to get it to start up quickly.
It is advised you call CA Support to discuss this option.
When the Archive Manager is started it sends a CHECK TABLE event; query to mysql.
Pending database size this can potentially take hours.
If the secondary Archive Manager is running and connected - there is no problem to be concerned with.
If there is no secondary, you may opt to remove all the archive manager data to get it to start up quickly.
It is advised you call CA Support to discuss this option.
Feedback
Yes
No
Powered by
