CA Gen application closes the connection to the DTU when many breakpoints are set
search cancel

CA Gen application closes the connection to the DTU when many breakpoints are set

book

Article ID: 100548

calendar_today

Updated On:

Products

Gen Gen - Workstation Toolset Gen - Host Encyclopedia Gen - Run Time Distributed

Issue/Introduction

An issue was reported where a Gen online module being run under the Diagram Trace Utility (DTU) closes the connection to the DTU when a certain number breakpoints are set. From the user's investigation it appears that the problem occurs when the application sends the DTU more than approximately 3KB of data corresponding to the set breakpoints.
The user found that reducing the number of break points resolves the problem. 

Environment

CA Gen 8.6 Diagram Trace Utility (DTU)

Cause

Root cause analysis required user to capture DTU trace for in-house recreation. That was not possible and the user was happy to use the workaround they had found
 

Resolution

Reduce the number of breakpoints set.